Study guide · 3.2
Dosage and infusion calculation
This topic covers the calculations a registered nurse does at the bedside: tablets and liquids, unit conversions, weight-based doses, infusion rates in mL/h and drops per minute, and infusions dosed in units or mg per kilogram. Questions give a prescription and a stock strength and offer the right answer beside the results of the common errors, so each step and the rounding matter.
A study feature written by ExamDragon, not part of the real exam and not from DOH. DOH publishes no blueprint: this topic and its area, Medication safety, are ours.
At a glance
Area 3- Mock questions
- 8
- Practice questions
- 8
- Key terms
- 8
What this guide covers
1One formula and a sense check
- Dose required / dose in stock x volume of stock gives the volume (or the number of tablets when the volume is one tablet).
- Put everything in the same units before you calculate (mg with mg, mL with mL, hours with hours).
- Estimate first: is the answer more or less than one tablet or one stock volume?
- Round only at the end, and as the question or the device requires.
- Recheck any answer of more than two or three tablets, or a volume that is unusual for the route.
- The situationMorphine 6 mg is prescribed and the solution is 10 mg in 5 mL.
- Step 1Estimate: 6 mg is a little more than half of 10 mg, so a little more than half of 5 mL.
- Step 2Calculate: 6 / 10 x 5 = 3.0 mL.
- Step 3Compare with the estimate before giving it.
- Where questions turnForgetting to multiply by the 5 mL gives 0.6 mL, which the estimate would catch.
- TakeawayEstimate, calculate, then compare.
2Units and conversions
- 1 g = 1000 mg; 1 mg = 1000 micrograms; 1 L = 1000 mL.
- Convert to the smaller unit to avoid decimals where you can.
- A percentage strength is grams in 100 mL: 1% = 1 g in 100 mL = 10 mg/mL.
- Write "micrograms" and "units" in full; abbreviations cause ten-fold and thousand-fold errors.
- Read the strength on the vial or bottle every time; many drugs come in several strengths.
- The situationDigoxin 125 micrograms is prescribed and the tablets are 0.25 mg.
- Step 1Convert: 0.25 mg = 250 micrograms.
- Step 2Calculate: 125 / 250 = 0.5 tablet.
- Step 3Check the tablet is scored before halving it.
- Where questions turnReading 0.25 mg as 25 micrograms gives five tablets, a ten-fold overdose.
- TakeawaySame units first.
3Weight-based doses
- Dose = prescribed amount per kg x weight in kg; use a recent, measured weight.
- Then convert the dose to a volume with the stock concentration.
- Check the total against the maximum dose in the drug reference.
- In adults under 50 kg some drugs, such as intravenous paracetamol, are dosed by weight rather than as a full adult dose.
- The situationAmikacin 15 mg/kg is prescribed for a 68 kg man, and the vial is 250 mg/mL.
- Step 1Dose: 15 x 68 = 1020 mg.
- Step 2Volume: 1020 / 250 = 4.08 mL, rounded to 4.1 mL.
- Step 3Check: 4 mL is 1000 mg, so just over 4 mL is right.
- Where questions turnDistractors include decimal slips (0.4 and 40.8 mL); the estimate rules them out.
- TakeawayWeight first, then volume.
4Infusion rates
- Pump rate (mL/h) = volume (mL) / time (hours); convert minutes to hours first.
- Drops per minute = volume (mL) x drop factor (drops/mL) / time (minutes).
- Read the drop factor from the giving set packet; standard and blood sets differ.
- Round drops to the nearest whole drop, and pump rates as the pump allows.
- Check: rate x time should equal the volume.
- The situation250 mL is prescribed over 90 minutes by pump.
- Step 1Convert: 90 minutes = 1.5 hours.
- Step 2Calculate: 250 / 1.5 = 166.7, rounded to 167 mL/h.
- Step 3Check: 167 x 1.5 is about 250 mL.
- Where questions turnTreating 90 minutes as 0.9 hours gives 278 mL/h.
- TakeawayHours for pumps, minutes for drops.
5Infusions in units and dose rates
- Concentration = total amount / total volume (for example 25 000 units / 50 mL = 500 units/mL).
- Rate (mL/h) = dose per hour / concentration; for a dose per kg, multiply by the weight first.
- To check a running infusion: dose per hour = rate x concentration.
- With 50 units of insulin in 50 mL, 1 mL = 1 unit; total units over a shift is each rate x its hours.
- Heparin, insulin and sedatives are high-alert: double check the calculation and the pump independently as policy sets out.
- The situationHeparin 25 000 units in 50 mL is prescribed at 18 units/kg/h for an 80 kg patient.
- Step 1Dose: 18 x 80 = 1440 units/h.
- Step 2Concentration: 25 000 / 50 = 500 units/mL.
- Step 3Rate: 1440 / 500 = 2.88, rounded to 2.9 mL/h.
- Where questions turnDividing by the 50 mL syringe volume instead of the concentration gives 28.8 mL/h, ten times the rate.
- TakeawayDose, then concentration, then rate.
Key terms
- Stock strength
- The amount of drug in a stated volume or unit of the preparation available, such as 10 mg in 5 mL.
- Concentration
- The amount of drug in each mL of a solution, such as 500 units/mL.
- Drop factor
- The number of drops in 1 mL delivered by a gravity giving set, printed on its packet.
- Volumetric pump
- A device that delivers a set volume in mL per hour.
- Syringe pump
- A device that delivers small, precise volumes from a syringe, often for high-alert drugs.
- Weight-based dose
- A dose prescribed per kilogram of body weight.
- Reconstitution
- Adding a stated diluent to a powder to make a solution of known concentration.
- Independent double check
- A second nurse works out the dose and checks the pump separately before comparing results.
Easy to confuse
- Leaving out the stock volume (dose / stock without x volume) or inverting the formula.
- Mixing units: mg and micrograms, litres and mL, minutes and hours.
- Dividing by the syringe or bag volume instead of the concentration in unit infusions.
- Using the wrong drop factor or strength because the packet or vial was not read.
After this guide: You should now be able to calculate tablets, liquid volumes, weight-based doses, pump rates, drip rates and unit infusions, round them as asked and spot the answer a common error would give.
Practise 3.2 (8 questions)